Jotun Jotafloor Topcoat is a high performance, two pack, polyamide cured epoxy coating. It is easy to apply and available in a range of colours, with excellent gloss and colour retention. It has good durability, chemical, abrasion and impact resistance. If slip resistance is required, Jotafloor Non-Slip Aggregate (fine or medium) can be used in the system. It is used as a topcoat in atmospheric environment.
- Good chemical, abrasion and impact resistance
- If enhanced slip resistance is required Jotafloor Non Slip can be used in the system.
- Suitable on approved primers on concrete substrates
- Available in any colours
- Good penetrating properties
|VOC Level ||386g / Litre |
|Coverage ||8.3m² / Litre |
|Touch Dry ||2 Hours 30 Minutes @ 10°C |
|Over-Coating ||14 Hours @ 10°C |
|Maintenance Cycle ||Comp A - 2 Years |
|Comp B - 4 Years |
|Thinning & Cleaning ||Jotun No.17 |
|Number of Coats ||2 |
Surface Preparation: All concrete damaged by exposure to chemicals, contaminated by any substance or unsound in any way, shall be removed to expose sound concrete.
Coated surfaces: Clean, dry and undamaged compatible primer.
Other surfaces: Concrete surface preparation by using dust free captive blasting units, grinding equipment, sand blasting or high pressure water jetting is critical to achieving the right surface profile prior to paint application.
Contact us for more information.The coating may be used on other substrates.
Typical Paint System:
Jotafloor Sealer 1 x 40 μm (Dry Film Thickness)
Jotafloor Topcoat 1 - 2 x 50 μm (Dry Film Thickness)
May also be used as a final coating on Jotafloor Screed.
Typical Use: Designed for a wide range of floors with various levels of mechanical and chemical exposure. Specially designed for floors where a dust free, hard wearing and aesthetically pleasing coating is required. Specially designed for industrial floors, laboratories, hospitals, food and beverage plants, kitchens, high tech manufacturing facilities, dairies, warehouses, factories and hangars.
Spray: Use airless spray.
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.
Roller: May be used. Care must be taken to achieve the specified dry film thickness.