ElmbridgeElmbridge

Jotun Tankguard 412
Jotun Tankguard 412
Jotun Paints

ICSC-JT412

Jotun Tankguard 412

In Stock

£152.75 (ex VAT)

£152.75
£152.75
  • Please select an option from the list above.

Manufacturer:   Jotun Paints

Description

Tankguard 412 is a two pack, solvent free, polyamine cured, epoxy coating, designed as a general purpose tank lining with good chemical resistance. It can also be used for corrosion protection for the internal lining of steel storage tanks and for friction reduction in gas pipes - please contact us for specific recommendations. 

  • Solvent free
  • High build
  • Can be used as primer, mid coat or finish coat in atmospheric and immersed environments

Substrates:

  • Properly prepared carbon steel
  • Galvanised steel
  • Stainless steel
  • Concrete
Application Method Airless Spray, Brush or Roller
Mixing Ratio (Volume) Tankguard 412 Comp A - 2 Parts
Tankguard 412 Comp B - 1 Part
Surfaces Marine / Buildings / Structured Steel 
VOC Level 118g / Litre
Coverage  2m² / Litre
Dry Touch  15 Hours @ 10°C / 1.5 Hours @ 40°C

Additional Information

Surface Preparation: To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination.
Carbon steel: Sa 2½ (ISO 8501-1)
Stainless Steel: Cleanliness and surface profile corresponding to Sa 2½, Fine G (ISO 8503-2)
Aluminium: Dry abrasive blast cleaning to SSPCSP 13/NACE No. 6.
Galvanised steel: Light brush blasting using nonmetallic abrasive leaving a clean, rough and even pattern.
Coated surfaces: Clean, dry and undamaged compatible coating (ISO 12944-4 6.1)

Typical Paint System: 
As a tank coating: Tankguard 412 2 x 200 microns (DFT) or Tankguard 412 1 x 300 microns DFT)
As internal pipe coating: Tankguard 412 1 x 80 -100 microns (DFT)
Other systems may be specified, depending on area of use.

Typical Use:
Marine: Can be used as a coating for potable water, grey water and crude oil tanks.
Protective: Recommended as an internal lining for offshore, onshore and buried tanks and recommended for offshore environments, including splash zones, refineries, power plants, bridges, buildings, mining equipment and general structural steel.

Application:
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.
Roller: Roller application only to be used for scallops, ratholes, small pipes etc.

Continue Shopping

We're here to help

Not sure which is the best product? Can’t find what you need?

Complete and submit this form for assistance from one of our specialist advisors.

Submit