ElmbridgeElmbridge

Jotun Tankguard HB
Jotun Tankguard HB
Jotun Paints

ICSC-JTHB

Jotun Tankguard HB

In Stock

£160.00 (ex VAT)

£160.00
£160.00
  • Please select an option from the list above.

Manufacturer:   Jotun Paints

Description

Tankguard HB is a two pack, high build, polyamine cured, epoxy coating with high resistance to a wide range of chemicals and solvents. Can be used as primer, mid coat or finish coat in atmospheric and immersed environments including interiors of tanks and gas pipes.

A separate resistance list is available on request.

  • High build
  • Excellent resistance to chemicals and solvent resistance
  • High resistance to petroleum products, hydrocarbons, alkalies, chemicals and intermediates
  • Good over-coating and cure timesSmooth surface
  • Can be used as primer, mid coat or finish coat in atmospheric and immersed environments
  • Suitable for properly prepared carbon steel, galvanised steel, stainless steel and concrete substrates.
Application Method Airless Spray, Brush or Roller
Mixing Ratio (Volume) Tankguard HB Comp A - 4 Parts
Tankguard HB Comp B - 1 Part
Surfaces Internal Tank Coating for Chemical Tanks
VOC Level  390g / Litre
Coverage  3.1m² / Litre
Touch Dry 12 Hours @ 5°C / 1.5 Hours @ 40°C
Over-Coating  36 Hours @ 5°C / 4 Hours @ 40°C
Maintenance Cycle 2 Years @ 23°C
Pot life @ 23°C 8 Hours
Thinning & Cleaning Jotun No.23
Number of Coats 2

Additional Information

Surface Preparation: To secure lasting adhesion to the subsequent product all surfaces shall be clean, dry and free from any contamination.
Carbon steel: Sa 2½ (ISO 8501-1)
Coated surfaces: Clean, dry and undamaged compatible coating (ISO 12944-4 6.1)
Concrete: Dry abrasive blast cleaning to SSPCSP 13/NACE No. 6.
Stainless steel: Abrasive blast cleaning to achieve a surface profile using approved nonmetallic abrasive media which is suitable to achieve a sharp and angular surface profile.
Galvanised steel: Light brush blasting using nonmetallic abrasive leaving a clean, rough and even pattern.

Typical Paint System: Tankguard HB 3 x 100 μm (DFT)
Other systems may be specified, depending on area of use.

Typical Use:
Marine: Designed as an internal tank coating for chemical tanks. This coating has good resistance to a wide range of products. Can be used as a coating for grey water, drilling mud, brine and crude oil tanks.
Protective: Recommended as an internal lining for offshore, onshore and buried tanks and pipes. 

Application:
Spray: Use Airless Spray.
Brush: Recommended for stripe coating and small areas. Care must be taken to achieve the specified dry film thickness.
Roller: Roller application only to be used for scallops, rat holes, small pipes etc.

Continue Shopping

Related Products

Jotun Thinner No.23
  • JT-23
  • Jotun Thinner No.23
  • From £29.50

We're here to help

Not sure which is the best product? Can’t find what you need?

Complete and submit this form for assistance from one of our specialist advisors.

Submit