Manufacturer: Marathon Coatings
Description
Primabond I is a single pack etching primer for application to suitably prepared non-ferrous and ferrous substrates such as aluminium, aluminium alloys, zinc and smooth iron and steel surfaces where high adhesion is required. This primer will provide a firm, highly adherent tie coat prior to the application of subsequent coats. Its excellent properties will combine ease of application together with rapid drying and etch to allow high volumes to be painted in a very short space of time.
- Excellent adhesion
- Single pack for ease of use
- Direct to galvanised surfaces
- Accepts forced drying
- Overcoat with most paints
Application Method | Spray |
Surfaces | Aluminium, Steel Surfaces |
VOC Level | 780g / Litre |
Coverage | 15m² / Litre |
Touch Dry | 15 Minutes @ 20°C |
Over-Coating | Drying Time Vary |
Maintenance Cycle | 2 Years |
Thinning & Cleaning | Marathon 737 |
Number of Coats | 2 |
Additional Information
Surface Preparation: All surfaces should be clean, dry and free from grease, rust, millscale, and etc. The primer base component should be well mixed and then the acid component should be added and mixed in the correct proportion. Apply in the normal manner ensuring that all areas are completely covered. For further information contact our technical department.
Typical Paint System: 1 x 60 μm Primabond I (DFT). Subsequent coatings to suit application.
Other systems may be specified, depending on area of use.
Typical Use: Can be used for aluminium, aluminium alloys, zinc and smooth iron and steel surfaces.
Application:
Spray Guns |
Conventional Spray: | 1.4 -1.8mm tip @ 3.5 - 4.2 bar |
Suction Feed: | 1.8mm tip @ 0.7 bar (Max) |
Pressure Pot: | 1.0 - 1.4mm tip @ 0.7 bar |
Continue Shopping