Rust-Oleum 7100 Floor Coating is a single pack, solvent based, Alkyd floor coating. It is specially designed for applying on weathered dry concrete for interior and exterior use. The coating has a good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistance during short contact periods against lubricating oils, fuel, petrol etc.
- Easy to apply
- Solvent based floor coating
- For foot traffic, interior and exterior use
- High gloss appearance
- Great hiding power
- Available in different RAL colours?
- Good resistance against abrasion and neutral detergents
- Resistance during short contact periods against lubricating oils, fuel, petrol
- Old concrete floors (>2 yrs)
|Application Method ||Brush or Roller |
|VOC Level ||456g / Litre |
|Coverage ||8m² / Litre |
|Touch Dry ||6 Hours @ 20°C |
|Over-Coating ||24 Hours @ 20°C |
|Maintenance Cycle ||5 Years |
|Thinning & Cleaning ||7301 |
|Number of Coats ||2 |
Surface Preparation: Cleaner/Degreaser for floors or high pressure - (steam) cleaning in combination with appropriate detergents. Sand old intact coatings to roughen the surface in order to establish a good adhesion. Check the compatibility with old intact coatings.
During application the surface should be dry and clean. On porous concrete a first coat should be applied with 7100 diluted with 10% 7301 Thinners. Remove curing compounds by means of dust free blasting.
Typical Paint System
7100 2 x 35 μm (Dry Film Thickness)
Typical Use: 7100 Floor Coating can be applied on concrete floors older than 2 years, which are completely clean and dry. It is not recommended to apply on smooth/dense concrete or concrete
containing a damp repellent additive, which will prevent a good adhesion.
7100 Floor Coating can also be applied on old good adhering coatings.
7100 can be applied onto metal floors which have been correctly prepared and primed with a
suitable Rust-Oleum metal primer.
Application: Brush: Sparingly, if required, with 10% 7301.
Roller: Sparingly, if required, with 10% 7301. In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.
Cleanup: Immediately after application using 7301.
Apply in a dry and well-ventilated area.