Manufacturer: Rust-Oleum
Description
Rust-Oleum 7100NS Anti-Slip is an easy to apply solvent based Alkyd floor coating specially designed for applying on weathered dry concrete (>2 years old) for interior and exterior use. The coating has a good resistance against abrasion and neutral detergents (no alkaline cleaning agents) and is resistant during short contact periods against lubricating oils, fuel, petrol etc.
- Single pack, solvent based anti-slip coating
- For foot traffic, interior and exterior
- Anti-slip additive is premixed in the coating
- Unique uniform appearance, high gloss
Substrates
- Old concrete (>2 yrs)
- Metal
- Wood
Use on
- Old good adhering coatings
- Metal floors which have been correctly prepared and primed with a suitable Rust-Oleum metal primer
Application Method | Brush or Roller |
VOC Level | 485g / Litre |
Coverage | 8m² / Litre |
Touch Dry | 6 Hours @ 20°C |
Over-Coating | 24 Hours @ 20°C |
Maintenance Cycle | 5 Years |
Thinning & Cleaning | 7301 |
Number of Coats | 2 |
Additional Information
Surface Preparation: Cleaner/Degreaser for floors or high pressure - (steam) cleaning in combination with appropriate detergents. Sand old intact coatings to roughen the surface in order to establish a good adhesion. Check the compatibility with old intact coatings. During application, the surface should be dry and clean.
On porous concrete a first coat should be applied with 7100 diluted with 10% 7301 Thinners. Remove curing compounds by means of dust free blasting.
Typical Paint System
7100 2 x 35 μm (Dry Film Thickness)
Typical Use: 7100 Floor Coating can be applied on concrete floors older than 2 years, which are completely clean and dry. It is not recommended to apply on smooth/dense concrete or concrete containing a damp repellent additive, which will prevent a good adhesion.
7100 Floor Coating can also be applied on old good adhering coatings.
7100 can be applied onto metal floors which have been correctly prepared and primed with a suitable Rust-Oleum metal primer.
Application:
Brush: Sparingly, if required, with 10% 7301.
Roller: Sparingly, if required, with 10% 7301. In case of roller application it can be necessary to apply 2 coats in order to obtain the recommended film thickness.
Cleanup: Immediately after application using 7301.
Apply in a dry and well-ventilated area.
Continue Shopping