ElmbridgeElmbridge

Rust-Oleum 9200 Rust-O-Thane
Rust-Oleum 9200 Rust-O-Thane
Rust-Oleum

MC-R9200R

Rust-Oleum 9200 Rust-O-Thane

Select a Colour
Search for your ideal colour or use the colour finder button to look up the colours we currently stock.

Selected Colour

 

 Can't find the colour you're looking for?

Use our colour match system to get the colour you need.

Select a colour to see the pricing information.

Manufacturer:   Rust-Oleum

Description

Rust-Oleum 9200 Rust-O-Thane is a water Based, Polyurethane topcoat. It provides excellent protection against UV, with an easy to clean semi-gloss finish.

  • Outstanding colour and gloss retention
  • Very low VOC
  • Resistant to solvents and chemical cleaning agents
  • High resistance to abrasion
  • Long-lasting satin finish
  • Also suitable for floors or walls
Application Method Spray, Brush or Roller
Surfaces Coated floors, walls and primed metal
VOC level 35g / Litre 
Coverage  6.2m² / Litre
Touch Dry 1 Hour 30 Minutes - 2 Hours @ 20°C
Over-Coating 24 Hours @ 20°C
Maintenance Cycle 2 Years
Thinning & Cleaning Water & Soap
Number of Coats 2

Additional Information

Surface Preparation: Remove grease, oil and all other surface contamination using alkaline or high pressure (steam) cleaning in combination with appropriate detergents. Sand previous coatings that are in good condition to remove gloss and to roughen the surface slightly. Assure that the previous coating is compatible with the RUST-O-THANE 9200 by making a test application! Remove bad adhering coatings by scraping, wire brushing or sanding. (Spot)prime with commended Rust-Oleum or Mathys coatings. The surface must be clean and dry during application.

 Typical Paint System

Suitable Primer to manufactures recommendation

9200 1 x 40µm (Dry Film Thickness)

Typical Use: For application on substrates, which are coated with Rust-oleum or Martin Mathys epoxy or acrylic coatings. The application areas consist of coated floors, coated walls, and primed metal. 

Application: Temperature of air, substrate and coating material between 5°C and 35°C and relative humidity below 80 %. The substrate temperature must be at least 3°C above dew point. 

Brush: Undiluted. Use natural bristles, longhair brushes.

Roller: Undiluted. Use medium nap (polyamide, 8-12 mm). Apply slowly in even strokes.

Airless spray: Undiluted. Pneumatic and electric airless equipment. Tip size: 0.013-0.015 inch. Fluid pressure: 200 bar.

Cleanup: Water and soap, before drying. 

Continue Shopping

We're here to help

Not sure which is the best product? Can’t find what you need?

Complete and submit this form for assistance from one of our specialist advisors.

Submit