Description
Rust-Oleum Pegakote is a two pack, water based, satin gloss, epoxy paint with very hard wearing properties designed for interior use on floors and walls. Exceptional abrasion resistance, resistant to oils and solvents, easy to clean, almost odourless and solvent free.
- Waterborne
- Easy to apply
- Very hard - exceptional abrasion resistance
- Resistant to oils and solvents
- Solvent free, almost odourless
- Easy to clean
Suitable for use in:
- Garages
- Warehouses
- Showrooms
- Corridors
- Indoor car parks
- Workshops, etc.
Application Method | Brush or Roller |
VOC Level | 140g / Litre |
Coverage | 1st Coat: 200 - 300m² / Litre |
2nd Coat: 300 - 400m² / Litre |
Touch Dry | 9 Hours @ 20°C |
Over-Coating | 18-20 Hours @ 20°C |
Maintenance Cycle | 2 Years |
Thinning & Cleaning | Water |
Number of Coats | 2 |
Additional Information
Surface Preparation
The substrate should be dry and clean, free from ascending humidity and sufficiently coherent (tensile strength min. 6 kg/cm2). Pegakote can be applied directly on most mineral substrates (ie. old concrete, tiles, glass etc).
Curing compounds in case of poly-concrete have to be removed by means of sand or grit blasting. On new concrete or non-porous concrete, remove cement grout by sand or grit blasting, treatment with diluted hydrochloric acid at a ratio of 3 l hydrochloric acid to 10 l water or with Surfa-Etch 108.
For these two last solutions, there is obligation to rinse abundantly and to allow drying through of the surfaces. Porous substrates shall be impregnated with Pegakote diluted with 10 to 20% water.
Typical Paint System
Pegakote 1 x 200gm
Pegakote 1 x 300gm
Typical Use: For garages, warehouses, showrooms, corridors, indoor car parks, workshops, etc.
Only for indoor works, as well for floors as for walls.
Application:
Brush: If necessary, dilute with water.
Roller: Dilute 1st coat with max. 10% water. Apply 2nd coat undiluted.
Air-atomised spray: Not recommended.
Airless Spray Gun |
Nozzle: | 021 - 023 / Pressure: 220 bar |
1st Coat: | Dilute with 5 - 10 Water |
2nd Coat: | Dilute with Maximum 5% Water |