Smooths uneven, damaged or worn concrete floors.
- Extremely durable
- Suitable for interior or exterior use
- Pre blended for easy mixing and fast application
- High mechanical strength
- Foot traffic possible after 6 hours
- Solvent free - Low odour
- From 3-15mm thickness possible
- Mixing paddle and spiked roller are necessary for use with this product
|Application Method ||Spike roller |
|Coverage ||3.75m² / Litre |
|Touch Dry ||6 Hours @ 15°C |
|Over-Coating ||24-36 Hours when laid at normal thickness |
|Maintenance Cycle ||1 Year |
|Thinning & Cleaning ||Water |
|Number of Coats ||2 |
Surface Preparation: Concrete should be free of loose material, soft surface laitance and contaminants. New concrete must be at least four weeks old. Remove all loose material by wire brushing. General dirt etc., should be removed with a strong neutral cleaner. Oil and grease can be removed with a Multi-Purpose Degreaser. Cracks in concrete should be raked out and all loose material removed.
Typical Use: For smoothing uneven, damaged or worn concrete floors. A pour on, durable re-surfacing material.
Application: Pour the mixed components onto the wet Primer 2. Use a trowel to spread the Speed Screed across the surface of the concrete at the desired thickness (it may be convenient to work to a thin batten but this must be removed before working further sections). It is not essential that trowel marks are removed at this stage. Immediately after application a spiked roller should be used to even out the material and release any trapped air. Use the spiked roller quite vigorously rolling each area 3 or 4 times from different directions. The spiked roller should not be used for more than 20 minutes as the Speed Screed will have started to cure and the roller may leave marks. If it is necessary to walk on areas of wet primer whilst applying Speed Screed care should be taken not to tread wet primer or Speed Screed onto surrounding surfaces.
Ambient temperature of approximately 15ºC - 20ºC and good ventilation. Lower temperatures will retard curing. Do not apply at less than 5ºC.